2000 Vauxhall Tigra

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security bumper/ tail gate (6.2.2 (d) (i))

CENTRE EXHAUST CORRODING ON CLAMP NOT BLOWING

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security BACK END CORRODED BEHIND BUMPER (6.2.2 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting OUTER SILL (6.2.2 (d) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting INNER SILL (6.2.2 (d) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting INNER SILL (6.2.2 (d) (i))

Offside Front Inner Tyre has a bulge, caused by separation or partial failure of its structure 185/55/15 (5.2.3 (d) (ii)) DANGEROUS

CENTRE EXHAUST CORRODING ON CLAMP NOT BLOWING

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security BACK END CORRODED BEHIND BUMPER (6.2.2 (d) (i))

Emissions not tested exhaust holed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases mid/rear (6.1.2 (a))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch holed (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch holed (6.2.2 (d) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security boot area (6.2.2 (d) (i))

Centre exhaust corroded

Front Anti-roll bar corroded but not seriously weakened anti roll bar corroded (2.4.G.1)

Rear Rear wheel bearing has slight play both rear (2.6.2)

Rear Shock absorber has slight corrosion to the casing both rear (2.7.2a)

Rear coil spring corroded both rear (2.4.C.1b)

Body has slight corrosion (6.1.B.2)

Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear coil spring corroded (2.4.C.1b)

Vehicle structure has slight corrosion (6.1.A.1)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Inner Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Inner Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Body has slight corrosion (6.1.B.2)

Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear coil spring corroded (2.4.C.1b)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear coil spring corroded (2.4.C.1b)

Power steering component(s) has slight seepage from a component (2.3.3b)

advise corrosion around both rear spring cups on chassis.

advise corrosion on exhaust system.

advise corrosion on front crossmember.

advise corrosion on rear axle beam.

advise corrosion on underside of vehicle.

advise quality of previous weleding repaires unknown.

advise wear on front wiper blades.

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nail in rear tyre

Non obligatory mirror damaged

Rear Shock absorber has a light misting of oil (2.7.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Suspension arm corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

coil spring corroded (2.4.C.1b)

corrosion to o/s door, no sharp edges present at time of test

rear axle is corroded but not seriously weakened

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Inner Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Registration plate lamp not working (1.1.C.1d)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nail in rear tyre

Non obligatory mirror damaged

Rear Shock absorber has a light misting of oil (2.7.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Suspension arm corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

coil spring corroded (2.4.C.1b)

corrosion to o/s door, no sharp edges present at time of test

rear axle is corroded but not seriously weakened

Non obligatory mirror damaged

Rear wheel bearing has slight play (2.6.2)

Horn not loud enough to be heard by another road user (1.6.2b)

Rear Exhaust system not adequately supported (7.1.1)

Rear Brake cable has wires broken but is not significantly weakened (3.5.1b)

Rear wheel bearing has slight play (2.6.2)

both rear tyres perished sidewalls

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear wheel bearing has slight play (2.6.2)

both rear tyres sidewalls perished

Horn not a constant note (1.7.1e)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear wheel bearing has excessive play (2.6.2)

Offside Headlamp aim too low (1.8)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear wheel bearing has slight play (2.6.2)

both rear tyres sidewalls perished

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Parking brake: efficiency below requirements (3.7.B.7)