2000 Iveco Dailey

Nearside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill holed and corroded but not in prescribed area (7.1.1 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both inner arches (5.3.6 (a) (i))

Nearside inner sill/out rigger holed and corroded but not in prescribed area

Offside Front chassis/panel corroded under bonnet

front reg plate deteriorated

oil leak

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Vehicle structure has slight corrosion inner sill support (6.1.B.2)

Nearside Front inner arch corroded

Nearside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill support (6.1.B.2)

Offside Front Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings inner arch (6.1.B.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Vehicle structure has slight corrosion inner sill support (6.1.B.2)

Nearside Front inner arch corroded

Nearside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

oil; leak

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

battery insecure

Nearside Front Headlamp aim too high (1.8)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

battery insecure

Brake pipe slightly corroded (3.6.B.2c)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Outer Front Seat belt retracting mechanism defective (5.2.5b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Leaf spring splayed and action impaired (2.4.B.1c)

Offside Rear Leaf spring splayed and action impaired (2.4.B.1c)

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Rear Rear position lamp(s) incomplete (1.1.4a)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre side walls on a twin fitment are contacting each other (4.1.D.3)

Offside Rear Rear position lamp(s) insecure (1.1.A.3a)