2001 Ford Cougar

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust mounting defective touching body and nearly touching fuel tank (6.1.2 (a))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust mounting defective touching body and nearly touching fuel tank (6.1.2 (a))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

o/s/f tyre cracked

whole car rusty

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded x2 front to rear (3.6.B.2c)

Offside Front Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings floor (6.1.B.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded x2 front to rear (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Fuel tank insecure (7.2.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Upper Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)