2000 Ford Puma

Nearside HEATER HOSE SPLIT

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced SILL (6.1.1 (c) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced SILL (6.1.1 (c) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced SILL (6.1.1 (c) (i))

Offside Rear Parking brake inoperative on one side LOW EFFORT (1.4.1 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside HEATER HOSE SPLIT

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired floor pan (6.2.2 (d) (ii)) DANGEROUS

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Offside Front tyre worn on inner edge

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings both rear inner sills (6.1.B.2)

Offside Front tyre worn on inner edge

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil Leak

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

exhaust has slight corrision

slight oil leak

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front brake disc slightly pitted (3.5.1h)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Front brake disc slightly pitted (3.5.1h)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)