2000 Audi A2

Front Brake disc worn, but not excessively both side (1.1.14 (a) (i))

Nearside Front Anti-roll bar attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Bonnet cannot be secured in the closed position lock inoperative (3.1 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen in an unacceptable condition view obstructed, windscreen damaged. (3.2 (c) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Front position lamp(s) obscured but not more than 50% (1.1.A.3c)

Front Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak ()

Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Tyre worn close to the legal limit all round (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)