2000 Subaru Impreza

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

outer sills not fully tested due to covers

Central Brake pipe excessively corroded Fuel tank area (1.1.11 (c))

Central Brake pipe excessively corroded Fuel tank area (1.1.11 (c))

Central Brake pipe excessively corroded Fuel tank area (1.1.11 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Central Brake pipe corroded, covered in grease or other material Fuel tank area (1.1.11 (c))

Exhaust has a minor leak of exhaust gases Center section flange very poor and leaking (6.1.2 (a))

Exhaust has a minor leak of exhaust gases Secondary center section flange very poor leaking (6.1.2 (a))

Nearside Front Play in steering rack inner joint(s) ()

Steering system slightly rough (2.1.1 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Plastic sill covers fitted so cant fully inspect sills

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle support cross member (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch area (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch area (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle support cross member (5.3.6 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake pipe slightly corroded both rear pipes starting to corrode (3.6.B.2c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

nearside front tyre wearing on inner edge

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front brake disc slightly pitted (3.5.1h)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Upper Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Upper Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)