2000 Suzuki Jimny

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central rubber fuel pipes are perished/cracking

Exhaust has a minor leak of exhaust gases rear box to center pipe gasket blowing (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bushes for the main control arm slightly worn (5.3.4 (a) (i))

Offside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bushes for the main control arm slightly worn (5.3.4 (a) (i))

Rear Oil leak, but not excessive rear diff (8.4.1 (a) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Fuel pipe leaking under vehicle (6.1.3 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Coil spring corroded both (5.3.1 (b) (i))

Nearside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Brake pipe corroded, covered in grease or other material running front-rear corroded and covered (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

nearside parking brake effort low

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Fuel Pipe/s corroded Vehicle undersealed Covering pipes

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Underside of vehicle has been fully undersealed

Rear Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Fuel Pipe/s corroded Vehicle undersealed Covering pipes

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Underside of vehicle has been fully undersealed

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired Inner sill and Leaf spring mount. (6.2.2 (d) (ii)) DANGEROUS

Corrosion behind front head light mounting points

Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Fuel Pipe/s corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Corrosion behind front head light mounting points

Fuel Pipe/s corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis has numerous points of corrosion which will need attention (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material Numerous ones around vehicle (1.1.11 (c))

Fuel Pipe/s corroded

Nearside Front Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced middle section by rear trailing arm mounting points corroded (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Side light dim

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Side light dim

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Seat belt damaged (7.1.2 (b) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Brake hose leaking on a hydraulic braking system (1.1.12 (c) (ii)) DANGEROUS

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

n/s/f tyre close

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

both rear wheel bearings have slight roughness.