2000 Mazda MX-5

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Headlamp levelling device cannot be operated from the driver's seat (4.1.5 (b))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Driver's view Items removed from driver's view prior to test (3.1 (a) (ii))

Front Headlamp lens slightly defective Both sides (4.1.1 (b) (i))

Front Lower Shock absorbers has a slightly worn bush Both sides (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded Both sides (5.3.1 (b) (i))

Rear Lower Shock absorbers has a slightly worn bush Both sides (5.3.2 (c))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Tyre slightly damaged/cracking or perishing All 4 (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Central Rear Upper Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Headlamp aim too high (1.8)

front and rear brake pads worn

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)