2001 Toyota Yaris

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Fuel Pipe/s corroded ()

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Rear Fuel Pipe/s corroded ()

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output Bothside (4.1.4 (b))

Nearside Rear Fuel Pipe/s corroded ()

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sills Both side (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Side (5.3.4 (a) (i))

Front Headlamp lens slightly defective Both Side (4.1.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Side (5.3.4 (a) (i))

Front Headlamp lens slightly defective Both Side (4.1.1 (b) (i))

Headlamp aim too low (4.1.2 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Side (5.3.4 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both Side (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Windscreen wiper not working (3.4 (a))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt both side (2.4.G.2)

Front engine light on the dash

Rear coil spring corroded both side (2.4.C.1b)

Front Headlamp aim too low both side (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt both side (2.4.G.2)

Front engine light on the dash

Rear coil spring corroded both side (2.4.C.1b)

Front Anti Roll Bar rubbers worn.

Parking brake lever has little reserve travel (3.1.6b)