2000 Mazda MX-5

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction (3.1 (a) (ii))

Front Registration plate missing (0.1 (a))

Front Windscreen washer not working (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear of under sill in wheel arch rusted and holed. (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Under sill rusted and holed. (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear of under sill in wheel arch rusted and holed. (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced O/S sill and under sill rusted and holed. (7.1.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis section visible from wheel is rusted and holed. (5.3.6 (a) (i))

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill rusted and holed. (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Under sill to Wheel arch rusted and holed. (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis visible by wheel has rusted and holed. It is also rusted through on the engine side of the chassis. (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill rusted and holed. (7.1.1 (a) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

under body surface rust

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

under body surface rust

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Inner Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Front Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Fluid leak, but not excessive box (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

under body surface rust

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm corroded but not seriously weakened upper and lower both sides (2.4.G.1)

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit just over 1.6mm (4.1.E.1)

Rear Suspension arm corroded but not seriously weakened ns/os (2.4.G.1)

Offside Rear Tyre worn close to the legal limit Under 3mm (4.1.E.1)

Rear registration plate faded but not likely to be misread (6.3.1d)

Nearside Rear Body has slight corrosion sill (6.1.B.2)

Offside Body has slight corrosion sill (6.1.B.2)

Offside Front Body has slight corrosion inner wheel arch (6.1.B.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

NEARSIDE REAR TYRE GETTING A BIT LOW APPROX 2MM IN PLACES

SLIGHT RATTLE IN CENTRE EXHAUST BOX