2001 Toyota Yaris

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases rear silencer (6.1.2 (a))

Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced rear sill on offside rear axle bush mounting (6.1.1 (c) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Anti-roll bar linkage pin or bush likely to become detached both sides (5.3.4 (a) (ii))

Rear Coil spring corroded (5.3.1 (b) (i))

under vehicle surface corrosion

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Coil spring corroded (5.3.1 (b) (i))

under vehicle surface corrosion

Offside Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp aim too low (1.8)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)