2000 Saab 9-3

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases flexi pipe (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases rear box (6.1.2 (a))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Under-trays fitted obscuring some underside components

front brakes noisy

small coolant leak

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Upper Steering component mounting prescribed area is distorted but not considered excessive (2.2.C.1h)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

advise bulkhead cracked and flexing at servo