1982 Honda CM125C

Centre Rear reflector on motorcycle incorrectly positioned (1.4.2d)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lever attachment screws missing (3.1.2b)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Front wheel bearings are slightly rough (2.3.5b)

Rear Brake pedal pivots slightly worn (3.1.3a)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Drive chain worn but not considered excessive (6.2.1e)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Front wheel bearings are slightly rough (2.3.5b)

Rear Brake pedal pivots slightly worn (3.1.3a)

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Tyre is incorrectly seated on the wheel rim (4.1.2b)

Fuel cap mounting flange/sealing method defective (7.2.2c)

Nearside Rear Footrest insecure (6.2.1a)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Drive chain worn but not considered excessive (6.2.1e)

Front Wheel has a slightly distorted bead rim. (4.2.2)

footpeg mounts are slightly worn

the lockstops have been repaired

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lining(s) close to minimum limit (3.2.A1f(i))

Front Wheel has a slightly eccentric bead rim. (4.2.2)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Brake lever mounting insecure (3.1.2a)

Nearside Front Direction indicator not working (1.5.1c)

Nearside Rear Direction indicator not working (1.5.1c)

Offside Front Direction indicator not working (1.5.1c)

Offside Rear Direction indicator not working (1.5.1c)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear reflector on motorcycle missing (1.4.1)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lining(s) close to minimum limit (3.2.A1f(i))

Front Wheel has a slightly eccentric bead rim. (4.2.2)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Oil leak

clutch cable fraying at top of cable

clutch lever pivot worn

drive chain has tight spots along the run of chain,

front tyre not fully seated out on rim

pillion footrests missing but bike has a grabrail fitted

Front mudguard insecure (2.3.7)

Rear Brake component is excessively corroded (3.1.5)

Front Wheel spoke slightly bent. (4.2.1b)

Front Wheel spoke slightly bent. (4.2.1b)

Headlamp aim too low (1.6)

Wheel alignment incorrect which adversely affects the handling (2.5.1)