1978 Ford Capri

Battery insecure (1.9.1)

Nearside Front Brake pipe excessively corroded on caliper (3.6.B.2c)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Rear Brake pipe inadequately supported across axle (3.6.B.1)

Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Front Brake hose slightly deteriorated perished and ferrule corroded (3.6.B.4d)

Nearside Front Brake pipe slightly corroded under bonnet (3.6.B.2c)

Nearside Front of outer sill holed by corrosion

Offside Front Brake pipe slightly corroded on caliper (3.6.B.2c)

Offside Front Brake pipe slightly corroded under bonnet (3.6.B.2c)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive inner wheel arch by strut top (2.4.A.3)

Offside Rear rear panel closing plate badly corroded and holed

noise from n/s/r brake when spun by hand

o/s/r bump stop missing

vehicle extensively modified and some parts obscured by plates

Front Brake pad(s) wearing thin (3.5.1g)

all brake pipes rusty

oil leakes around steering rack

under body has been modifed ,Extensive welding and additional parts fitted, various sealers and fillers used to fill gaps between body kit

Brake pedal anti-slip provision missing (3.3.A.1b)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Front Headlamp aim too high (1.8)

Front Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Brake hose inappropriately repaired (3.6.A.3)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

oil leakes around steering rack poss rack /tranmission

under body has been modifed extensive welding and additional parts fitted ,Various sealers and fillers used to fill gaps

Bonnet retaining device ineffective (8.4.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Side repeater not working (1.4.A.2c)

Offside Side repeater not working (1.4.A.2c)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

boot not tested

Direction indicators not working (1.4.A.2c)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a part missing (7.1.1a)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Brake lining(s) insecure (3.5.1g)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Leaf spring has excessive side play at eye (anchor) (2.4.B.4)

Nearside front brake binding (3.7.B.1)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Leaf spring has excessive side play at eye (anchor) (2.4.B.4)

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Rear Suspension spring mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Offside Rear Suspension spring mounting prescribed area is inadequately repaired (2.4.A.3)