2001 Renault Master

Nearside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill in three places along the length (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill in 2 places along the length (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Central Front Electrical wiring inadequately secured (4.11 (a) (i))

Central Rear Anti-roll bar damaged but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive sill door step (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner and outer sills both sides, marked with chalk (6.2.2 (d) (i))

Nearside Front Lower Brake pipe excessively corroded to flexi (1.1.11 (c))

Rear Leaf spring anchor bracket corroded and seriously weakened both rear spring rear mounts excess corrosion (5.3.1 (b) (i))

Front Service brake binding but not excessively both (1.2.1 (f))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

bothside inner and outer sills corroded

Fuel cap/sealing device ineffective wont open (6.1.3 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Battery insecure (1.9.1)

Central Front Seat belt retracting mechanism defective (5.2.5b)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

all upper and lower front suspension arm ball joint have slight movement

slight underbody corrosion

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Horn not working (1.6.2a)

Nearside Headlamp aim too high (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake binding (3.7.B.1)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear discs in poor condition

Nearside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

smoke opacity close to fail limit

Nearside outer track rod end joint cover split/missing

Offside outer track rod end joint cover split/missing

Oil leak

smoke opacity close to fail limit