2001 Subaru Legacy

EML lamp on

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too low (1.8)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

EML lamp on

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Cut in offside rear tyre, not deep enough to reach ply or cords

Engine management light indicates there is a fault

Offside wiper blade split

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Stop lamp not working (1.2.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)