2001 Toyota Yaris

Emissions not tested due to leak (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp has a product on the lens or light source which significantly reduces light intensity (4.2.3 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Fuel Pipe/s corroded ()

MIL light on

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Fuel Pipe/s corroded ()

MIL light on

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive outer sill (7.1.1 (a) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive outer sill (7.1.1 (a) (i))

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear outer sill slightly corroded

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

suspension has surface rust

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

hand brake has travel

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too low (1.8)

Offside front brake application uneven (3.7.B.2)

hand brake has travel

Offside Front Tyre worn close to the legal limit (4.1.E.1)

slight hand brake travel

rear tyres cose to wear limit

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front screen is cracked but not in the swept area

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not working (1.1.5c)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

high level brake light not working