2001 Hyundai Santa Fe

floorpan/suspension corroded

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

floorpan/chassis corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe excessively corroded front to rear x2 (1.1.11 (c))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component pin or bush slightly worn top bush (5.3.4 (a) (i))

Offside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component pin or bush slightly worn top bush (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material n/s/ & o/s front (1.1.11 (c))

Front Drive shaft joint worn, but not excessively n/s & o/s (6.1.7 (c) (i))

Fuel Pipe/s corroded ()

Nearside Front shock absorber ineffective damping

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Brake pipe corroded, covered in grease or other material n/s/ & o/s front (1.1.11 (c))

Front Drive shaft joint worn, but not excessively n/s & o/s (6.1.7 (c) (i))

Fuel Pipe/s corroded ()

Nearside Front shock absorber ineffective damping

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake lever has little reserve travel (3.1.6b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Offside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Oil leak

exhaust system corroded throughout

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Stop lamp not working (1.2.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Front Headlamp aim too low (1.8)

Offside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Offside Front Headlamp aim too low (1.8)

Oil leak

exhaust system corroded throughout

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Service brake grabbing severely (3.7.C.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.C.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Hi level stop lamp inop.