2001 Toyota Yaris

Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Emissions not tested (8.2.2.2 (e))

Nearside Rear Inner Vehicle structure is fractured and structural rigidity is significantly reduced sill (6.1.1 (a) (i))

Nearside Rear Service brake grabbing severely (1.2.1 (c))

Offside Rear Service brake grabbing severely (1.2.1 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Front Braking system leaking bleed nipple (3.6.A.1)

Offside Front Suspension arm attachment bracket/mounting insecure bolt loose (2.4.G.1)

Offside Front front brake recording little or no effort (3.7.B.5a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Headlamp has a product on the lens so that the light output is severely reduced milky (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp has a product on the lens so that the light output is severely reduced milky (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner and outer sill (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear coil spring broken (2.4.C.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)