2001 Mitsubishi Shogun

Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security offside & nearside, inner wings in engine bay (6.2.2 (d) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Brake pipe corroded, covered in grease or other material pipe to hose in the inner wing (1.1.11 (c))

Offside Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Outer Suspension arm corroded but not seriously weakened front & rear, offside & nearside, upper & lower (5.3.3 (b) (i))

Rear Brake hose has slight corrosion to ferrule offside & nearside (1.1.12 (f) (i))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive wheel arches, lower, behind, road wheels (5.3.6 (a) (i))

Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside, behind the ends of the sills jacking point arears (5.3.6 (a) (i))

Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside, lower wheel arches & outer sills (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Central Exhaust has a minor leak of exhaust gases center box out put pipe (7.1.2)

Front Oil leak ()

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Rear Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt upper & lower (2.4.G.2)

Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive behind the end of the sills, offside & nearside (2.4.A.3)

Offside Front Lower Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Lower Body has slight corrosion inner under side behind sill (6.1.B.2)

Offside Upper Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Lower Body has slight corrosion outer arch to sill in door closure (6.1.B.2)

Nail in offside rear tyre

Offside Front Upper Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Inner Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Outer Rear Lower Body has slight corrosion (6.1.B.2)

Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear coil spring incomplete (2.4.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

nsf wiper split