2001 Mercedes-benz Vito

Nearside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner /outer sill (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis rails (6.1.1 (c) (i))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Front Outer body badly corroded

Offside Front Outer badly corroded

Offside Front drivers door bottom badly corroded

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis rails (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Central Exhaust has a major leak of exhaust gases forward of box (6.1.2 (a))

Central Rear Exhaust has a major leak of exhaust gases of box (6.1.2 (a))

Front Registration plate insecure (0.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened faces (1.1.14 (a) (ii))

Nearside Rear Coil spring worn (5.3.1 (b) (i))

Offside Rear Coil spring worn (5.3.1 (b) (i))

genral under side corrosion

Headlamp aim not tested both (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Brake hose excessively twisted (1.1.12 (b) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Nearside Front Body panel corroded and likely to cause injury (6.2.1 (a) (i))

Nearside Rear Brake hose excessively chafed (1.1.12 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Body panel corroded and likely to cause injury (6.2.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Lower Integral body structure is corroded but structural rigidity is not significantly reduced underside (6.1.1 (c) (i))

Nearside Non obligatory mirror damaged ()

outer body corroded

Nearside Rear Suspension spring mounting prescribed area is excessively corroded inner (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Nearside rear brake binding bind from handbrake (3.7.B.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Steering rack gaiter split (2.2.D.2d)

Registration plate lamp not working (1.1.C.1d)

outer body very corroded

under side very corroded

entire underside of vehicle is in a state of corrosion

previous welded repairs have been carried out to a poor standard

Offside Rear Registration plate lamp not working (1.1.C.1d)

entire underside of vehicle is in a state of corrosion

previous welded repairs have been carried out to a poor standard

Park brake effort low

Welded repairs cannot be fully inspected due to a heavy coating of underseal

Park brake effort low

Stop lamp not working (1.2.1b)

Welded repairs cannot be fully inspected due to a heavy coating of underseal

Nearside Front Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded outer and inner sills (2.4.A.3)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer and inner sills (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Play in steering rack inner joint(s)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

corrosion on n/s and o/s inner and outer sills

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Parking brake lever has no reserve travel (3.1.6b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Play in steering rack inner joint(s)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

corrosion on n/s and o/s inner and outer sills

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both inner and outer sills corroded

Nearside Front Anti-roll bar has excessive play in a pin/bearing (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both inner and outer sills corroded

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

both inner /outer sills corroded

n/s/f bearing slightly rough

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Inner Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Registration plate lamp not working (1.1.5c)

Windscreen wiper blade deteriorated (8.2.2)