2001 Jaguar XK8

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember next to mounting points (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch behind main crossmember (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill at rear (7.1.1 (a) (i))

Offside Rear Exhaust has a minor leak of exhaust gases centre box (6.1.2 (a))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting cross member (6.2.2 (d) (i))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch (6.2.2 (d) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Rear Subframe mounting prescribed area is corroded but not considered excessive both rear ends (2.4.A.3)

Front Body has slight corrosion crossmember (6.1.B.2)

Front Body has slight corrosion inner wings (6.1.B.2)

Nearside Rear Body has slight corrosion chassis leg (6.1.B.2)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Front Anti-roll bar has slight play in a pin/bush D bush (2.4.G.2)

Offside Front tyre worn on inner edge

Rear Sub-frame corroded but not seriously weakened :A; frame (2.4.G.1)

Nearside Front Body has slight corrosion (6.1.B.2)

Offside Front Body has slight corrosion (6.1.B.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)