2001 Toyota Yaris

Fuel hose deteriorated Fuel filler hose is rusty (6.1.3 (c) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm on 1.28mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing also wearing on inner edge (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Tyre worn close to the legal limit Slightly out of shape on inner edge (4.1.E.1)

NSR tyre out of shape

OSR tyre perished

Parking brake lever has little reserve travel (3.1.6b)

handbrake travel high

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/r seatbelt not tested (childseat fitted)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)