2001 Saab 9-3

Exhaust has a minor leak of exhaust gases and corroded (6.1.2 (a))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust mounting defective rubber missing (6.1.2 (a))

both rear tyres tread cracking

engine oil leak

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust mounting defective rubber missing (6.1.2 (a))

both rear tyres tread cracking

engine oil leak

Oil leak ()

Nearside Front Wheel bolt(s) missing (4.2.A.1e)

Registration plate lamp not working (1.1.C.1d)

Oil leak ()

Nearside front seat will not tilt

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear (2.4.G.2)

Offside front inner wheel arch corroded and trim loose

Rear exhaust silencer corroded

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Centre Stop lamp not working (1.2.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front front brake binding (3.7.B.1)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear fog lamp not working (1.3.2b)

Rear front brake binding (3.7.B.1)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement inner bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit tread condition 3mm (4.1.E.1)

Nearside Front seat will not tilt

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre worn close to the legal limit tread condition 3mm (4.1.E.1)

Offside Front corrosion on offside front wheel arch also trim adrift on arch

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

all four brake discs in poor condition due to corrosion

brake warning lamp on

corrosion on front shock absorbers

exhaust rear silener corroded on outer skin

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

n/s/r tyre worn on inside egde

o/r/r tyre has small cracks

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front coil spring incomplete (2.4.C.1a)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)