2001 Mercedes-benz Vito

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

GENERAL UNDERBODY CORROSION

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive box section (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Windscreen damaged but not adversely affecting driver's view small crack (3.2 (a) (i))

under side of vehicle showing surface corrosion

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Inner Front constant velocity joint is insecure (2.5.C.1b)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake load sensing valve seized (3.6.E.3)

Headlamp aim too low (1.8)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front coil spring incomplete (2.4.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Offside Brake pipe slightly corroded (3.6.B.2c)