2001 Aprilia RS125R

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear suspension bearing has slight free play (2.4.A2a(i))

Headlamp aim too high (1.6)

Clutch lever worn and bush missing.

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear brake pedal worn and bent.

Steering movement slightly 'notchy' (2.2.1b)

Clutch lever adjuster worn.

Gear lever clamp loose.

Riders r/h footpeg worn.

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Clutch lever worn and bush missing.

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear brake pedal worn and bent.

Speedo cable fitted wrong.

Steering movement slightly 'notchy' (2.2.1b)

Clutch lever adjuster worn.

Gear lever clamp loose.

Riders r/h footpeg worn.

Drive chain worn to excess (6.2.1e)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Drive chain sprocket worn to excess (6.2.1e)

Front position lamp damaged and function impaired (1.1.1b)

Headlamp aim too low (1.6)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Brake pedal is bent but brake can still be readily applied (3.1.3c)

Brake pedal pivots slightly worn (3.1.3a)

Bush missing out of clutch lever.

R/h footpeg worn.

Steering movement slightly 'notchy' (2.2.1b)

Gear lever loose.

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front wheel bearings have excessive free play (2.3.5b)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Front Brake lever attachment screws missing (3.1.2b)

Front Front wheel bearings are excessively rough (2.3.5b)

Front Front wheel bearings have excessive free play (2.3.5b)

Headlamp aim beam image kick up to the offside (1.6)

Nail in rear tyre

Drive chain slightly loose (6.2.1d)