2001 Jaguar Xjr

Nearside Front Forward inner sill área corrded

Offside Front Forward inner sill área corroded

Nearside Front Forward inner sill area corroded

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Forward inner sill area corroded

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Rear Bumper insecure (6.1.4 (a) (i))

Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Front Forward inner sill area corroded

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Forward inner sill area corroded

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength seal (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength seal (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Nearside Front Jacking point area rusty

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Jacking point area rusty

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

general under body rust

under trays fitted

under side of vehicle heavily undersealed

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

fuel lines corroded

n/s/f seat belt slow to retract

o/s/f tyre scrubbed offf on inside edge

Nearside Front Shock absorber has an excessively worn linkage (2.7.4)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Shock absorber has an excessively worn linkage (2.7.4)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

fuel lines corroded

n/s/f seat belt slow to retract

o/s/f tyre scrubbed offf on inside edge

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside front inner sill has corrosion but not within prescribed area

Nearside Headlamp aim too far to the right (1.8)

Nearside rear brake binding (3.7.B.1)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside front inner sill has corrosion but not within prescribed area

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Headlamp aim too low (1.8)

Headlamp insecure (1.7.3)

Nearside Front Seat belt retracting mechanism defective (5.2.5b)

Rear fog lamp tell tale not working (1.3.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Drive shaft uj which forms part of the suspension has excessive play in a universal joint (2.4.G.4b)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

o/s/r 2mm-o/s/f-2mm -n/s/r 3mm of tread left

small chip in centre of windscreen