2001 Mercedes-benz Vito

Nearside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Headlamp aim too high (1.8)

Nearside Rear Passenger's seat insecure (6.2.A.1)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Outer Front Brake pipe excessively corroded (3.6.B.2c)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Outer Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear coil spring incomplete (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake load sensing valve linkage seized (3.6.E.3)

n/s/front tyre void of tread to inner + outer edges

o/s inner cv boot split

o/s/rear shock dust cover corroded

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

clutch pedal anti slip worn and damage to o/s mirror casing

cut in n/s/f tyre

light scratching to windscreen

Brake load sensing valve linkage seized (3.6.E.3)

Emissions not tested (7.0)

Front Exhaust has part of the system excessively deteriorated (7.1.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Registration plate lamp not working (1.1.5c)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust noisy (7.1.4)

Front Brake pad(s) wearing thin (3.5.1g)

Centre Exhaust has a part missing (7.1.1a)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamps matched pair are not the same colour (1.7.6)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear brake disc excessively pitted (3.5.1h)

Parking brake lever has no reserve travel (3.1.6b)

Child seat fitted not allowing full inspection of adult belt

cut in n/s/f tyre †

exhaust heat shield insecure

n/s/f door mirror cracked

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)