2001 Volvo S80

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

All direction indicators slightly discoloured (4.4.3 (a))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front tyre cracking

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

engine light on

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front tyre cracking

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

engine light on

Offside rear parking brake recording little or no effort 64kg (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

all four tyres worn on edges

fuel filter slightly corroded

Nearside Front position lamp(s) not working (1.1.A.3b)

all four tyres worn on edges

fuel filter slightly corroded

E M Light on

both front tyres low on edges

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

E M Light on

Nail in offside rear tyre

both front tyres low on edges

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

n/s/r tyre has slight damage to side walls

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

engine light on

n/s/r tyre has slight damage to side walls

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Side repeater slightly discoloured (1.4.A.2f)

near-side rear tyre outer wall ridged due to under inflation

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Side repeater slightly discoloured (1.4.A.2f)

near-side rear tyre outer wall ridged due to under inflation

both front tyres low on edge +n/s/f tyre inner side wall slight damage but no cords showing

centure exhaust mount broken

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)