2001 Peugeot 306

Nearside Rear Upper Seat belt anchorage prescribed area is corroded but not considered excessive corroded to legal limit (7.1.1 (a) (i))

Subframe mounting prescribed area is corroded but not considered excessive offside & nearside rear upper (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

Nearside Rear Brake hose porous (1.1.12 (e))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Upper Seat belt anchorage prescribed area is corroded but not considered excessive corroded to legal limit (7.1.1 (a) (i))

Subframe mounting prescribed area is corroded but not considered excessive offside & nearside rear upper (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

skuttle has some corrosion

Offside Front Position lamp not working (4.2.1 (a))

Windscreen in such a condition that visibility through swept area is seriously affected (3.2 (c) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

skuttle has some corrosion

both rear tyres worn badly on inner edges ,recommend early renewal

high imbalance recorded at front service brake

Fuel cap/sealing device sealing washer deteriorated (7.2.4c)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front coil spring broken (2.4.C.1a)

both rear tyres worn badly on inner edges ,recommend early renewal

high imbalance recorded at front service brake

Nearside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively offside and nearside (8.2.2)

brake servo hose deteriorated near to legal limit

front registration plate deteriorated to legal limit recommend renewal

rear shock absorbers feel soft

Nearside Rear Tyre tread depth below requirements of 1.6mm 185/65r14 86h (4.1.E.1)

front registration plate deteriorated to legal limit recommend renewal

rear shock absorbers feel soft

both rear tyres on or near legal limit 185/65r14 86h

offside front door top hinge worn

offside front inner brake pad appears low recomend wheels off inspection

radiator leaking [not mot item]

Offside Front position lamp(s) not working (1.1.A.3b)

both rear tyres on or near legal limit 185/65r14 86h

offside front door top hinge worn

offside front inner brake pad appears low recomend wheels off inspection

radiator leaking [not mot item]

high imbalence recorded at front brakes

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

nail in offside rear tyre[ not repairable] nail in nearside rear tyre [flat prior to test]

rear silencer deteriorated near to legal limit recomend early renewal

rear silencer rusty starting to leak

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

both front flexi brake hoses perished recomend early renewal

offside front tyre inner sidewall perished starting to split

rear silencer rusty starting to leak

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Registration plate lamp not working (1.1.C.1d)

front brakes binding slightly

front section exhaust cracked ,blowing to legal limit recomend early renewal

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

front brakes binding slightly

front section exhaust cracked ,blowing to legal limit recomend early renewal

high imbalence recorded at rear brakes

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Registration plate lamp not working (1.1.5c)

Exhaust mounting missing (7.1.1b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake pads appear low?

high imbalence recorded at rear brakes

Nearside Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Suspension arm has excessive play in a pin/bush (2.4.G.2)

1 pads not checked †2 sills not checked, covered

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.5c)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)