2001 Gilera Dna

Nearside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Offside Front footpeg locking device missing

Steering headbearing has slight free play (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

rear hub bearing very noisy when rear wheel rotated

Brake performance not tested no front o/s/ brake lever to perform out test fully (1.2.1 (g))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Brake lever is so short that the brake cannot be readily applied (1.1.2 (d))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Stop lamp not working (4.3.1 (a) (ii))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Offside Front footpeg locking device missing

Steering headbearing has slight free play (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

rear hub bearing very noisy when rear wheel rotated

unable to see thickness of rear pads

Front suspension has inadequate damping effect. (2.3.6c)

Rear Stop lamp does not illuminate immediately a brake applies control (1.3.1a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front suspension has inadequate damping effect. (2.3.6c)

Headlamp aim beam image kick up to the offside (1.6)

engine bush

Front suspension has a slightly reduced damping effect (2.3.6c)

Front suspension has a slightly reduced damping effect (2.3.6c)

Offside Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front shock absorber has light misting of stanchion (2.3.3)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front shock absorber has light misting of stanchion (2.3.3)

Front suspension assembly slightly corroded. (2.3.1)

Nearside Front shock absorber has light misting of stanchion (2.3.3)