2001 Lexus RX300

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear subframe bushes deteriating

Rear suspension components corroded

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive arch (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

headlamp output slightly reduced

Fluid leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Fluid leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Coil spring corroded both (5.3.1 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both front lower arm rear bushes perishing (5.3.4 (a) (i))

Front Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Fuel Pipe/s corroded fuel filler pipe corroded ()

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both rear trailing arm front bushes (5.3.4 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt both (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Coil spring corroded both (5.3.1 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both front lower arm rear bushes perishing (5.3.4 (a) (i))

Front Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Fuel Pipe/s corroded fuel filler pipe corroded ()

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both rear trailing arm front bushes (5.3.4 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

both front tyres worn on edges

general underside surface corrosion

Nearside Headlamp aim projected beam image is obviously incorrect lense faded (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect lense faded (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch (5.3.6 (a) (i))

both front wiper blades split

general underside surface corrosion

both front tyres worn on edges

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch/sill end (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch/sill end (5.3.6 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

both front tyres badly worn on inner edges

Headlamp aim poor

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Headlamp aim poor

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Rear Front suspension has slight play in a pin or bush of an lower wishbone inner bearing (2.5.B.1a)

Nearside Outer Rear Front suspension has slight play in a pin or bush of an lower wishbone inner bearing (2.5.B.1a)

Nearside front tyre wearing on both edges.

Engine covers fitted obscuring some components in the engine bay

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

Offside Front Tyre worn close to the legal limit (4.1.E.1)

under side of vehicle going rusty