2001 Rover 45

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel tub/floor pan (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel tub/floor pan (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor pan (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Headlamp aim not tested (1.8.A.1c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Battery insecure (1.9.1)

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Subframe mounting prescribed area is excessively corroded floor pan (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Water leak.

Nearside Front Suspension component mounting prescribed area is excessively corroded floor pan (2.4.A.3)

Water leak.

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Registration plate lamp not working (1.1.C.1d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Side repeater slightly discoloured (1.4.A.2f)

Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

engine management light on

front brake disc shields corroded

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Emissions not tested (7.0)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rust on fuel tank straps okat this time.

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rust on fuel tank straps okat this time.

Non obligatory mirror damaged

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

sounds that there may be a slight blow from the exhaust manifold area