2001 Jaguar Xkr

Underbody has underseal all over

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pipe excessively corroded Both sides front to back (1.1.11 (c))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength Underneath sill area and close to rear arm mounting point (5.3.6 (a) (i))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength Underneath sill area and close to rear arm mounting point (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure Very close to limit as well (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Underbody has corrosion all over including suspension components, mounting points , rear subframe both sides sills and floor

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength Under sill area near rear arm mounting (5.3.6 (a) (i))

Offside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength Under sill area, near rear arm monting (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure Split, inner sidewall, plus tread at 2mm (5.2.3 (d) (ii)) DANGEROUS

Extensive corrosion all over underside of vehicle

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced all round (6.1.1 (c) (i))

Central Brake pipe slightly corroded (3.6.B.2c)

Brake pipes slightly corroded

General underbody surface corrosion

both front floor pans corroding

both front to rear metal brake pipes corroded

both front tyres worn on inner edges

both headlamp aims on upper limit

both rear closing sills corroded

o/s number plate lamp slightly dim

rear exhaust clamps in poor condition

slight corrosion to both outer sills

slight corrosion to rear brake discs

under wheel arches covered

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

engine overheating

n/s/f floor pan corroded

n/s/f tyre worn low on inner edge

o/s front to rear metal brake pipe corroded

o/s/f tyre wearing low

oil leak from rear axle

Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Registration plate lamp not working (1.1.5c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)