2001 Iveco Daily

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust noisy flexi (8.1.1 (a))

Gearbox mounting defective ()

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Play in steering rack inner joint(s) ()

Windscreen damaged but not adversely affecting driver's view scratched (3.2 (a) (i))

body has surface corrosion

chassis has surface corrosion all over

driver seat torn

handbrake lever has slight travel

leaf spring corroded

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust noisy flexi (8.1.1 (a))

Gearbox mounting defective ()

Play in steering rack inner joint(s) ()

Windscreen damaged but not adversely affecting driver's view scratched (3.2 (a) (i))

body has surface corrosion

chassis has surface corrosion all over

driver seat torn

leaf spring corroded

anti slip rubber deteriorated-drivers seat torn-oil leak, due to oil leak unable to check components properly-o/s/r tyre inner wall/edge starting to perish-x2 front flexi hoses starting to deteriorate

parking brake has travel and passed on limit-all welding covered by substance, unable to check properly

x2 rear leaf springs corroded-rear brake disc corroded, pitted and juddering-x2 rear wheel bearings have slight play-front suspension arms corroded-front bumper insecure-o/s/r shocker damp

Battery insecure (1.9.1)

Nearside Front Subframe mounting prescribed area is excessively corroded sub frame holed, visible from n/s/f inner wheel arch (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis leg to inner sill holed, x2 (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Subframe mounting prescribed area is excessively corroded sub frame holed (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded outer sill holed (2.4.A.3)

Offside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill holed and inadequately repaired (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

anti slip rubber deteriorated-drivers seat torn-oil leak, due to oil leak unable to check components properly-o/s/r tyre inner wall/edge starting to perish-x2 front flexi hoses starting to deteriorate

x2 rear leaf springs corroded-rear brake disc corroded, pitted and juddering-x2 rear wheel bearings have slight play-front suspension arms corroded-front bumper insecure-o/s/r shocker damp

exhaust system coroded-oil leak/due to oil leak unable to check components properly

front bumper insecure-driver seat torn-leaf springs x2 cororded-o/s/r/ shocker damp

inner and outer sills cororded-anti slip worn-nearside mirrir casing secured by tape

rear brakes slightly juddering

welding covered by substance unable to check properly-parking brake passed on limits

x2 rear wheel bearings slight play

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Stop lamp not working both (1.2.1b)

Suspension component mounting prescribed area is excessively corroded n/s/f/ inner arch holed (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s/f/ chassie leg to inner sill holed (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s/f/ inner wheel arch holed (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s/r/ outer sill holed (2.4.A.3)

Tyre tread depth below requirements of 1.6mm n/s/r/ inner tyre (4.1.E.1)

exhaust system coroded-oil leak/due to oil leak unable to check components properly

front bumper insecure-driver seat torn-leaf springs x2 cororded-o/s/r/ shocker damp

inner and outer sills cororded-anti slip worn-nearside mirrir casing secured by tape

rear brakes slightly juddering

x2 rear wheel bearings slight play

rear brakes passed on limits-parking brake cables corroded-

x2 front inner chassie legs corroded/distorted and weak

x2 leaf springs corroded

x2 leaf springs corroded-

x2 outer and x2 inner sills corroded-

x2 rear wheel bearings slight play

anti slip ruber deteriated-oil leak, due to oil leak unable to check components properly-exhaust corroded-exhaust mountings corroded-chasis legs corroded-leaf springs corroded-front brake pads worn low

brake pedal spongy and parking brake passed on limits

x2 front ball joints have slight lift-steering box has slight play-x2 rear wheel bearings have slight play-dif oil leaking

Bonnet retaining device ineffective (8.4.2)

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Brake pedal spongy (3.3.B.1b)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Fuel tank insecure (7.2.1)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on main beam (1.7.5a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Statutory seat belt missing (5.1.1)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

anti slip ruber deteriated-oil leak, due to oil leak unable to check components properly-exhaust corroded-exhaust mountings corroded-chasis legs corroded-leaf springs corroded-front brake pads worn low

x2 front ball joints have slight lift-steering box has slight play-x2 rear wheel bearings have slight play-dif oil leaking

Brake valve retaining device missing (3.6.A.2d)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Statutory seat belt missing (5.1.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Direction indicators incorrect colour (1.4.A.2f)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake lever has no reserve travel (3.1.6b)

Rear Body insecure and dangerous to other road users (6.1.B.1b)

Battery insecure

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Oil leak

previous damage to the rear bumper but the rear lamps are facing to the rear

sediment/spillage around the fuel tank

Nail in offside rear tyre

parking brake travel is high but theres reserve travel at present

Front registration plate character(s) incorrectly spaced (6.3.4a)

Offside Registration plate lamp not working (1.1.5c)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Horn not working (1.6.2a) DANGEROUS

Nearside Front Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Battery insecure

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Oil leak

previous damage to the rear bumper but the rear lamps are facing to the rear

sediment/spillage around the fuel tank

Nail in offside rear tyre

parking brake travel is high but theres reserve travel at present

Brake cable has wires broken and is significantly weakened (3.5.1b)

Front Front position lamp(s) not working (1.1.A.3b)

Front Front wheel bearing has excessive play (2.5.A.3c)

Front Headlamp not in a clean condition affecting beam image (1.2.4a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear rear parking brake recording little or no effort (3.7.B.6a)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Body insecure and dangerous to other road users (6.1.B.1b)

Centre Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Lower Ball joint has excessive play (2.2.B.1f)

Offside Rear fog lamp excessively deteriorated so that it is not visible from a reasonable distance (1.3.2d)

Offside Rear rear brake binding (3.7.B.1)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Parking brake: efficiency below requirements (3.7.B.7)

Offside rear fog lamp lens broken. †Both sides front body bolts loose. †Handbrake travel could be improved.