2001 Mercedes-benz Vito

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outrigger (5.3.6 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material To flexy pipe (1.1.11 (c))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Centre sill (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Tow bar to chassis (5.3.6 (a) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Seal (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Seal (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Seal (6.1.1 (c) (i))

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive Seal (2.4.A.3)

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive Seal (2.4.A.3)

Offside Front coil spring broken (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Both sides (6.1.B.2)

Brakes not tested

Offside rear brake pipe corroded

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both rear tyre treads wearing uneven

offside outer cv boot loose on flange but preventing the ingress of dirt

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Direction indicator slightly discoloured (1.4.A.2f)

both rear tyres slightly out of shape

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

offside inner c.v gaiter split