2001 Mazda 626

Emissions not tested car keeps cutting out (7.3.A.1)

Nearside Front Tyre tread depth below requirements of 1.6mm 205/50/16 (4.1.E.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings chassis leg (6.1.B.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

1 of 2 rear exhaust bracket snapped

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

both front flexi brake hoses perished

both front top mount rubbers slightly worn

both rear anti roll bar bushes slightly worn

both rear coil springs corroded

child seat fitted

f/o/s cv boot starting to crack and perish

fuel fill neck bracket snapped

r/o/s tyre perished

rear brake discs badly corroded

rear brake pads getting low

strong smell of fuel around fuel tank and filler neck,

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

osf tyre wall perishing,underside of vehicle poor condition.

Front Exhaust system not adequately supported (7.1.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp aim too low (1.8)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

osf tyre wall perishing,underside of vehicle poor condition.

Brake servo corroded but not excessively weakened (3.6.A.2b)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nail in nearside rear tyre

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Shock absorber has slight external damage to the casing (2.7.2a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

all front locking suspension locking nuts corroded and weak

all front suspension fixings and bushes in poor condition

all rear suspension fixings and bushes in poor condition

engine oil sump corroded

front exhaust bracket clamp corroded and insecure

rear brake discs corroded

slight knocking noise from nearside of the vehicle

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake servo corroded but not excessively weakened (3.6.A.2b)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nail in nearside rear tyre

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Shock absorber has slight external damage to the casing (2.7.2a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

all front locking suspension locking nuts corroded and weak

all front suspension fixings and bushes in poor condition

all rear suspension fixings and bushes in poor condition

engine oil sump corroded

front exhaust bracket clamp corroded and insecure

rear brake discs corroded

wipers not fully tested for clearing the windscreen (no washers)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front front brake binding (3.7.B.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc slightly pitted (3.5.1h)

Rear brake disc slightly pitted (3.5.1h)

Front registration plate insecure (6.3.1b)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc slightly pitted (3.5.1h)

Rear brake disc slightly pitted (3.5.1h)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside front brake binding (3.7.B.1)

Front brake disc slightly pitted (3.5.1h)