2001 Peugeot Boxer

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Emissions unable to be completed (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Fuel system component leaking Injectors (6.1.3 (b) (i))

Horn sound not in accordance with requirements (7.7 (c))

Nearside Front Brake prescribed area is excessively corroded (1.1.21 (e) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced By engine mount (6.1.1 (c) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Lower Body panel corroded and likely to cause injury (6.2.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Brake prescribed area is excessively corroded (1.1.21 (e) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced By engine mount (6.1.1 (c) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength 2 areas (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust silencer insecure (8.1.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Outer Sill badly corroded

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust tailpipe corroded

Nearside Front Inner wheel arch corroded

Offside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive by brake hoses (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive w/ arch (5.3.6 (a) (i))

Nearside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength I/4 inner by road spring marked (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength of spring and tow bar (5.3.6 (a) (i))

Rear Trailer electrical socket wiring insulation damaged or deteriorated and likely to cause a short-circuit (4.10 (b) (ii))

Trailer electrical socket likely to become detached corroded plastic tie clipped to ball (4.10 (a) (ii))

Nearside Front Brake pipe inadequately clipped or supported by fuel tank (1.1.11 (d) (i))

Offside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive by brake hoses (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive w/ arch (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

rear tyres cracking

Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear position lamp(s) incorrect colour (1.1.A.3e)

Offside Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)