2001 Kymco Zing

Nearside foot rest rubber missing

Drive chain excessively loose (6.2.1d)

Front Plate brake test indicates a sticking brake (3.3.B1a)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Brake component has restricted free movement and operation is likely to be impeded cable not seated correctly near foot brake (3.2.A1h)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Nearside foot rest rubber missing

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Plate brake test indicates a binding brake (3.3.B1a)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Brake pedal has inadequate reserve travel (3.1.3b)

Rear Lower Brake locking device insecure (3.2.A1e)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Plate brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.B2b) DANGEROUS

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Position Lamp Remains On When Headlamp Is Switched Off

Front Tyre Sidewall Slightly Craqcked Due To Age, No Excessive Cracks Or Cord Showing

Front Tyre worn close to the legal limit (4.1.3(ii))

Gear Linkage Worn

Nearside Riders Footpeg Rubber Missing

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Rear Tyre Sidewall Slightly Cracked Due To Age, No Excessive Cracks Or Cord Showing

Rear Wheel spoke slightly corroded. (4.2.1b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain worn to excess (6.2.1e)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Upper Rear suspension bearing has excessive free play (2.4.A2a(i))

Drive chain excessively loose (6.2.1d)

Front Brake lever cannot be applied smoothly (3.1.3d)

Front suspension assembly component excessively misaligned (2.3.1)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Roller brake test indicates brake effort rise disproportional to brake lever or pedal effort (3.3.A1c)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Throttle operating incorrectly (6.2.1f)

Wheel alignment incorrect which adversely affects the handling (2.5.1)