2001 Mazda MX-5

Front lower crossmember corroded

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Nail in tyre ()

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Nail in tyre ()

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

front and rear sub frames corroded

general corrosion to all suspension components

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

front and rear sub frames corroded

general corrosion to all suspension components

Central Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings subframe support bar holed due to corrosion. (6.1.B.2)

Nearside Rear Brake pipe excessively corroded corroded at flexi joint (3.6.B.2c)

Nearside Rear Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings rear sills not fully seam welded (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe inadequately supported front- middle- and rear plastic pipe holders insecure (3.6.B.1)

Offside Front Fuel pipe insecure front - middle- and rear insecure (7.2.1)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Central Rear front and rear suspension components painted over corrosion.

Nearside Front Seat belt cut but not affecting the operation of the belt (5.2.2a)

Nearside Front perished in between tread.

Offside Front perished in between tread.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear subframe bushes perished

nearside inner sill corroded at front

offside chassis leg corroded

offside sill damaged

rear exhaust joint corroded

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear subframe bushes perished

nearside inner sill corroded at front

offside chassis leg corroded

offside sill damaged

rear exhaust joint corroded

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

chassis rusty

exhaust in poor condition

front suspension

oil leak

slight exhaust blow

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Braking system leaking (3.6.A.1)

Parking brake lever has no reserve travel (3.1.6b)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

chassis rusty

exhaust in poor condition

front suspension

oil leak

slight exhaust blow

general under body corrosion

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Offside Front Braking system leaking (3.6.A.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Parking brake lever has no reserve travel (3.1.6b)

general under body corrosion

corrosion in both chassis rails

corrosion in genaral floor area

corrosion in n/s/rear outer cill

corrosion in o/s/rear outer cill

front subframe corroded

front suspension components corroded

o/s/rear metal brake pipe corroded

rear subframe corroded

rear suspension components corroded

under tray fitted but is loose

Lower Anti-roll bar corroded and seriously weakened (2.4.G.1)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Headlamp aim too low (1.8)

Front Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

corrosion in both chassis rails

corrosion in genaral floor area

corrosion in n/s/rear outer cill

corrosion in o/s/rear outer cill

front subframe corroded

front suspension components corroded

o/s/rear metal brake pipe corroded

rear subframe corroded

rear suspension components corroded

under tray fitted but is loose

advanced corrosion all suspension arms,axle assembly,exhaust and heatshields

advanced corrosion rear brake discs

rear brake pads recheck 3000 miles

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

general corrosion to chassis

heavy corrosion to suspension components

Emissions not tested (7.0)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

general corrosion to chassis

heavy corrosion to suspension components

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.5c)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear brake discs ridged

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear brake discs ridged