2001 Mazda E Series

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside rear lamp lens damaged

Seat belt webbing slightly damaged or frayed drivers (7.1.2 (b) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake performance not tested (1.2.1 (g))

Exhaust has a major leak of exhaust gases centre box (6.1.2 (a))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside rear lamp lens damaged

Seat belt webbing slightly damaged or frayed drivers (7.1.2 (b) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases tail pipe (6.1.2 (a))

Front Exhaust mounting defective downpipe (6.1.2 (a))

slight corrosion to underside of vehicle

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases tail pipe (6.1.2 (a))

Front Exhaust mounting defective downpipe (6.1.2 (a))

slight corrosion to underside of vehicle

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill panel and inner arch by mudflap (7.1.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill panel (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded near fuel tank (1.1.11 (c))

Offside Rear Brake pipe excessively corroded nr fuel tank (1.1.11 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill panel (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill panel (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer sill panel corroded but outside prescribed areas

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Outer sill panel corroded but outside prescribed areas

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear tail pipe is very corroded by rear mount will need new tail pipe soon

slight play in front wheel bearings but not much at all

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front Steering column universal joint has slight play (2.1.5)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion on both inner and outer rear sill panels

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Front Steering column universal joint has slight play (2.1.5)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion on both inner and outer rear sill panels

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Nearside rear brake grabbing slightly (3.7.A.5b)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

nearside and offside rear light lenses