2001 Aprilia RS125R

Front Shock absorber has a serious fluid leak LH FORK SEAL LEAKING EXCESS (5.3.2 (b))

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Shock absorber has slight external damage to the casing Reduced damping (5.3.2 (b))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Rear Position lamp not working (4.2.1 (a))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Shock absorber has slight external damage to the casing Reduced damping (5.3.2 (b))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Front shock absorber has light misting of stanchion (2.3.3)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Sprocket carrier bearing slightly rough

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Front shock absorber has light misting of stanchion (2.3.3)

Headlamp aim too high (1.6)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Sprocket carrier bearing slightly rough

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front wheel bearings are slightly rough (2.3.5b)

Front suspension has excessive stiffness in the suspension movement. (2.3.6b)

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front wheel bearings are slightly rough (2.3.5b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp aim too low (1.6)

Offside Front Upper Handlebar mounting clamp bolt loose (2.1.1a)

Offside Rear Brake master cylinder fluid level dangerously low (3.2.B1d)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Exhaust noisy (7.1.2)