2001 Ford Puma

Front Headlamp lens slightly defective Both side (4.1.1 (b) (i))

Front Inner Suspension arm pin or bush worn but not resulting in excessive movement Both side (5.3.4 (a) (i))

Front Upper Macpherson strut mounting damaged but not seriously weakened Both side (5.3.3 (b) (i))

General corrosion underneath

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring mounting corroded but not seriously weakened Both side (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases rear box (6.1.2 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front front shock corroded

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front front shock corroded

Brake cable damaged (1.1.15 (a))

Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Smell of petrol fumes very strong unable to detect cause

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Power steering pump leaking from a failed component (2.3.3b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)