2001 Subaru Legacy

Integral body structure is corroded but structural rigidity is not significantly reduced Underbody (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Suspension component mounting prescribed area is inadequately repaired Inner sill (5.3.6 (a) (i))

Rear Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Windscreen washer not working (3.5 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Underbody and subframes showing signs of light surface corrosion (6.1.1 (c) (i))

Rear Exhaust has a minor leak of exhaust gases At rear exhaust hanger (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Nearside Front Outer Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced Underbody and subframes showing signs of light surface corrosion (6.1.1 (c) (i))

Nearside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Rear Exhaust has a minor leak of exhaust gases At rear exhaust hanger (6.1.2 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear coil spring corroded both (2.4.C.1b)

Nearside Rear Upper Bonded suspension unit deteriorated but can function as intended axle bush (2.4.F.3)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Upper Bonded suspension unit deteriorated but can function as intended axle bush (2.4.F.3)

Offside Rear coil spring corroded (2.4.C.1b)

Offside Rear Tyre worn close to the legal limit worn on inner edge (4.1.E.1)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)