2001 Land Rover Range Rover

Electronic stability control warning lamp not working (7.12 (e))

Exhaust has a minor leak of exhaust gases both rear silencers have pinholes (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Steering linkage ball joint has slight play steering box drop arm ball joint (2.1.3 (b) (i))

Brake hose has slight corrosion to ferrule all brake hoses (1.1.12 (f) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Suspension arm pin or bush worn but not resulting in excessive movement all bushes on front axle (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake hose has slight corrosion to ferrule all hoses (1.1.12 (f) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Suspension arm pin or bush worn but not resulting in excessive movement all bush's on front axle perishing around pins (5.3.4 (a) (i))

ABS Light illuminates and stays on when stationary, however it distinguishes when in motion

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Emissions unable to be completed (8.2.2.2 (e))

Exhaust on a vehicle fitted with a diesel particulate filter emits visible smoke of any colour (8.2.2.2 (d))

Fuel system component leaking From under the bonnet (6.1.3 (b) (i))

Nearside Front Inner Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

ABS Light illuminates and stays on when stationary, however it distinguishes when in motion

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both (2.1.3 (g) (i))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Headlamp not working on main beam (1.7.5a)

Engine covers fitted obscuring some components in the engine bay

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Child seat fitted not allowing full inspection of adult belt

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Child seat fitted not allowing full inspection of adult belt

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Track rod end ball joint has excessive play (2.2.B.1f)

Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)