2001 Lexus GS300

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced floor/sill (6.1.1 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced floor/sill (6.1.1 (c) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced floor/sill (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced floor/sill (6.1.1 (c) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill showing signs of corrosion but covered by plastic cover (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Rear Brake pad(s) incorrectly mounted assembly pin missing and tie strap fitted to hold pads in (1.1.13 (c)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill showing signs of corrosion but covered by plastic cover (6.1.1 (c) (i))

Nearside Front Upper Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Hydraulic brake calliper damaged however, braking performance not affected.

Brake lever has insufficient reserve travel Parking brake pedal. (1.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Upper Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Hydraulic brake calliper damaged however, braking performance not affected.

Nearside Upper Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Anti-lock braking system warning lamp indicates an ABS fault Also VSC warning light (3.4.1c)

Offside Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre wearing on outer edge.

Offside Front Tyre wearing on outer edge.

Tape removed from Instrument cluster to check operation of ABS/VSC warning light - OK - refitted.

nsf tyre side wallsplit no cords exposed nsf outer edge scrubbd no cords exposed

osf tyre sidewall split no cords exposed

osr tyreside wall split no cords exposed