2006 Fiat Scudo

Nearside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Power steering pipe/hose excessively corroded (2.1.5 (g) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Offside Front Suspension arm insecure and impairing directional stability ball joint pin moving in hub (5.3.3 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Macpherson strut mounting corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Macpherson strut mounting corroded but not seriously weakened (5.3.3 (b) (i))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front both front o/s & n/s suspension top mount plates corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Headlamp aim too low (1.8)

Offside Front Inner Front constant velocity joint is insecure (2.5.C.1b)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Exhaust system not adequately supported insecure & blowing on joint (7.1.1)

Anti-lock braking system component slightly damaged abs pump bracket corroded (3.4.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Brake hose has slight corrosion to ferrules both (3.6.B.4e)

Vehicle structure slightly damaged within 30cm of towbar mounting rear panel holed 33cm from towbar mounting point (6.6.6)

engine stabiliser mount has excessive movement

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Emissions not tested due to exhaust blow (7.4.B.1)

Exhaust has a major leak of exhaust gases backbox holed (7.1.2)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Anti-lock braking system component slightly damaged abs pump bracket corroded (3.4.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Brake hose has slight corrosion to ferrules both (3.6.B.4e)

Vehicle structure slightly damaged within 30cm of towbar mounting rear panel holed 33cm from towbar mounting point (6.6.6)

engine stabiliser mount has excessive movement

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)