2003 Microcar Virgo Prestige SE Auto

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Parking brake inoperative on one side Both (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake hose slightly chafed all 4 corners (1.1.12 (b) (i))

slight corrosion to front and rear sub frames

Exhaust has a major leak of exhaust gases center/ front (6.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust system insecure section held on by rope (6.1.2 (a))

Brake hose slightly damaged all brake hoses front and rear are damaged from fouling suspension (1.1.12 (b) (i))

Brake pipe corroded, covered in grease or other material all brake pipes greased (1.1.11 (c))

Nearside Rear parking brake reading low

eml on

front and rear subframe and axle components are corroded but not excessively

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front section of exhaust rubbing on cross member

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Emission control equipment obviously defective (8.2.1.1 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Front Bumper insecure (6.1.4 (a) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Sub-frame ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp insecure bolt missing (4.1.1 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Bumper insecure (6.1.4 (a) (i))

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Central Rear Brake hose slightly damaged cable tie too tight (1.1.12 (b) (i))

Nearside Front Brake hose slightly damaged cable tie too tight (1.1.12 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake hose slightly damaged cable tie too tight (1.1.12 (b) (i))

no reserve travel in hand brake

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Road wheel fixings not compatible (5.2.2 (d))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)