2006 Mazda 3

Exhaust has a minor leak of exhaust gases at seams and joints (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides rear mountings (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

under body corrosion to all areas

Exhaust has a minor leak of exhaust gases at seams and joints (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides rear mountings (5.3.4 (a) (i))

Offside Front Headlamp not working on dipped beam renewed bulb (4.1.1 (a) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

under body corrosion to all areas

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Outer sill covers fitted, both sides.

Vehicle structure is corroded but structural rigidity is not significantly reduced slight under-body. (6.1.1 (c) (i))

Driver's view of an obligatory external mirror materially affected by an obstruction (3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Outer sill covers fitted, both sides.

Vehicle structure is corroded but structural rigidity is not significantly reduced slight under-body. (6.1.1 (c) (i))

lower sill covers fitted

suspension components corroded

under body corrosion front and rear

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

lower sill covers fitted

suspension components corroded

under body corrosion front and rear

engine management light on

vehicle underbody heavily corroded

Exhaust system not adequately supported centre hanger broken (7.1.1)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear (2.4.G.2)

Offside Front Tyre(s) incorrect because a lightweight or space saving wheel is fitted (4.1.A.1b)

Rear Body has a sharp edge caused by damage bumper (6.1.C.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear tyre perished

engine management light on

vehicle underbody heavily corroded

Exhaust system corroded.

Front sub frame corroded.

General under body corrosion.

Offside Rear tyre perished.

Rear sub frame corroded.

Offside Rear Registration plate lamp not working (1.1.C.1d)

Play in steering rack inner joint(s)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside rear tyre deteriorated

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)