2008 Mercedes-benz Vito

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive floor to sill (5.3.6 (a) (i))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive arm (5.3.6 (a) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive floor to sill (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive arm (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive spring mount (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced floor (6.1.1 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced floor (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Seat belt anchorage prescribed area is corroded but not considered excessive both sides (7.1.1 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive and rear jacking points (5.3.6 (a) (i))

Brake pipe excessively corroded front to rear at center (1.1.11 (c))

Nearside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick pad on metal (1.1.13 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive jacking point area (5.3.6 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive jacking point area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Front Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Seat belt anchorage prescribed area is corroded but not considered excessive both sides inner/outer sills (7.1.1 (a) (i))

Front Shock absorbers has light misting of oil both sides (5.3.2 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive and rear chassis and inner/outer sills (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Front Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Seat belt anchorage prescribed area is corroded but not considered excessive both sides inner/outer sills (7.1.1 (a) (i))

Front Shock absorbers has light misting of oil both sides (5.3.2 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive and rear chassis and inner/outer sills (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material all around (1.1.11 (c))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both inner sill (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement Both sides linkage (5.3.4 (a) (i))

Front Brake pipe corroded, covered in grease or other material To rear various places (1.1.11 (c))

Front Tyres wearing on outer edge

Front Anti-roll bar pin or bush worn but not resulting in excessive movement Both sides linkage (5.3.4 (a) (i))

Front Brake pipe corroded, covered in grease or other material To rear various places (1.1.11 (c))

Front Tyres wearing on outer edge

Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii))

Offside Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust held by temporary fixing at rear

Near side front tyre worn on outer edge

Brake pipe slightly corroded all steel (3.6.B.2c)

Nearside Front Lower Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Brake pipe slightly corroded all steel (3.6.B.2c)

Brake pipe excessively corroded front to nearside rear (3.6.B.2c)

Brake pipe excessively corroded front to offside rear (3.6.B.2c)

Exhaust system not adequately supported x 3 (7.1.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside front brake binding (3.7.B.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear coil spring broken (2.4.C.1a)

Offside rear brake binding (3.7.B.1)

front brake application uneven (3.7.B.2)

rear brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too low (1.8)

Nearside Rear Wheel bolt(s) loose (4.2.A.1e)

Offside Headlamp aim too low (1.8)

Registration plate lamp not working (1.1.C.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Seat belt stitching slightly frayed (5.2.2b)

small bulge on nearside front tyre outer sidewall

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

small bulge on nearside front tyre outer sidewall